HCG injection protocol question

If you do your sub q shots right under the skin it will also burn more because the closer to the skin, the more nerve endings there are. Go a bit deeper and it won't burn as much.

The burn goes away quickly so not too bothered by it, but dang that needle, felt like a was injecting with a bic pen:lol:

Will do the back loading to preserve needle sharpness.

First time reconstituting HCG today. When I stuck the needle into the vial to inject the water air hissed out and the "powder" disappeared before I could inject the water.

Did I screw something up?

Once the water was in the vial it is slightly off colour.

The vail with the powder in is under vacuum. Even when holding back the plunger most of the bac water will get pulled into the vail.

A while back someone inserted the needle into the vail without holding the plunger and apparently it foamed up, MA said that this does damage the solution but to what extent who knows.

If it just got pulled in and dissolved the powder it should still be fine.

pr0gr3s1v3 wrote: The vail with the powder in is under vacuum. Even when holding back the plunger most of the bac water will get pulled into the vail.

A while back someone inserted the needle into the vail without holding the plunger and apparently it foamed up, MA said that this does damage the solution but to what extent who knows.

If it just got pulled in and dissolved the powder it should still be fine.

I read that post before attempting reconstitution so when I pierced the rubber stopped I made sure I held the plunger of the syringe in order for that not to happen.

After the air hissed out I had to push the plunger to get the water in.

Not sure then where the powder disappeared to, are you sure it didn't just mix with a bit of water that got sucked in when you inserted the needle? It mixes very quickly, even in a little water.

I hope so, like I said the solution in a slightly off white colour and the shot stung like hell. Not sure if plain sabax water would sting like that.

Not sure about the water either maybe some of the experienced guys can answer that.

Personally think its fine.

In future first use a syringe with just air in to pierce the vial and deal with the hectic vacuum issue. Then dribble the sabax water slowly down the side of the vial. Do not squirt directly onto the lyophilised hcg powder and do not shake the solution.

It's the salt in the sabax water that is responsible for most of the burn.

Muscleaddict wrote: In future first use a syringe with just air in to pierce the vial and deal with the hectic vacuum issue. Then dribble the sabax water slowly down the side of the vial. Do not squirt directly onto the lyophilised hcg powder and do not shake the solution.

It's the salt in the sabax water that is responsible for most of the burn.

Thanks for the tip. I think I'll get a new vial to be on the safe side.

Safehouse wrote:

Muscleaddict wrote: In future first use a syringe with just air in to pierce the vial and deal with the hectic vacuum issue. Then dribble the sabax water slowly down the side of the vial. Do not squirt directly onto the lyophilised hcg powder and do not shake the solution.

It's the salt in the sabax water that is responsible for most of the burn.

Thanks for the tip. I think I'll get a new vial to be on the safe side.

Used a syringe with air as you suggested Muscleaddict and it worked perfectly in sorting out the vacuum issue, so thanks a lot.

My HCG vial came with 10ml of a Bodene manufactured sodium chloride solution, and not the 2ml SABAX dropper as before.

The Bodene product did not sting at all, while the previous one did.

PoisonedPulse wrote: I don't understand how you guys are getting confused... As a general rule of thumb try use 2ml water for all your solutions, this eliminates unecessary confusion...

5000iu hcg powder mixed with 2ml water = 5000iu in 2ml, therefore 2500 iu of hcg in 1ml, if you want 250iu you divide by 10, just as admin explained, so will be like below

2500iu(1ml) / 10 = 250iu(0.1ml)

0.1ml on an insulin needle is 10 units ... (always remember 100 units equals 1ml)

So for the guys using there hcg with 2ml mixing solution, you will be shooting 10 units (250iu) twice a week.

Hope that made sense haha

The problem IS ..., a lot of people are simply mathematically challenged.....!
This explains things perfectly.

Howzit Guys,

I just want to know my hcg did not come with any bac water, can I get this from the pharmacy?

Yes you can. Ask for sterile inject able water. 2ml.

thank you Oupa

@ oupa or anyone please,

I went to the pharmacy to get injection water it came in a 5ml amp and it says pharma q water. Is this correct?

What does the label say it contains? 0.9% NaCl solution?

Hi MA

the vial says " each 5 ml contains WATER FOR INJECTION"
There is nothing about what it contains.

S1 SABAX Water for Injections 5ml B ?

Oupa it does not say sabax water it says from the top

s1 pharma-q-water for injection 5ml
not to be administered alone/moet nie aleen toegedien word nie
each 5 ml contains/elke 5 ml bevat:
Water for injection/water vir inspuiting
5ml Ampoule
PHARMA-Q HOLDINGS (pty) ltd

I confirmed with a few guys, they have used it with no issues to mix their HCG, i have personally not used it.

I would say its good to go as the guys i know still have their testicles.

Haha dankie vir jou hulp Oupa ek waardeur dit.

Has anybody used the HCG pre filled pens, the pens you get on prescription. It's 250μg pre filled pen.

admin wrote:

Kkkyle wrote: If you injecting 250ui with a 1ml insulin syringe would that be then 25 units?

It's easy. If you have HCG 5000iu and use 2ml water to reconstitute it you will get 2500iu per ml, so to get your 250iu you will take 0.1ml. (1ml/10)

Hey Guys

Needs some assistance, starting PCT in 2 weeks and just want to make sure I know what I'm doing.
A friend organised me the cycle, so I don't have direct contact with dealer

Anyway
as recommended, dealers message was to take 60iu Pregnyl every 4th day??
1 Clomid tab every day till tabs finished??

Does it sound right?

My question is, as per above quote, I have HCG and 2ml water...
Not sure how many ml I should be taking....Would it be less than 0.1ml every 4 days????
How long is a PCT cycle normally?????


Thanks

PhatZilla wrote: Hey Guys

Needs some assistance, starting PCT in 2 weeks and just want to make sure I know what I'm doing.
A friend organised me the cycle, so I don't have direct contact with dealer

Anyway
as recommended, dealers message was to take 60iu Pregnyl every 4th day??
1 Clomid tab every day till tabs finished??

Does it sound right?

My question is, as per above quote, I have HCG and 2ml water...
Not sure how many ml I should be taking....Would it be less than 0.1ml every 4 days????
How long is a PCT cycle normally?????


Thanks

www.anabolicsteroids.co.za/articles/info...9-post-cycle-therapy